OpenDuino
From syn2cat - HackerSpace.lu
(Difference between revisions)
| Line 11: | Line 11: | ||
[[Image:OpenDuino.jpg|none|400px]] | [[Image:OpenDuino.jpg|none|400px]] | ||
| + | |||
| + | == Usage == | ||
| + | * There is a little button you can find near the two LEDs. If you are the first to enter the space, push it so that the green LED is on. If you are the last one to leave, push it so that the red LED is on (the red LED is glowing quite weak). This will then change the status on the webpage. | ||
| + | * After reboot or reset of OpenDuino it will recover the currently active open/close status shown on the webpage. | ||
| + | * Following a more general power loss, OpenDuino will go into the close state (red LED is on). If you don't put it into green mode, the closed status will be published to the website after 5 minutes. | ||
| + | * There is a webserver running on OpenDuino at http://openduino.lan/. it currently only shows the status of the LEDs | ||
| + | |||
== Features == | == Features == | ||
Revision as of 00:19, 13 December 2009
 | |
|---|---|
| OpenDuino is a hard- and software solution to notify site visitors of the hackerspace occupation status | |
| |
| Meetings: | |
| Type: | misc
|
| Status: | running |
| Members: | Azunix, Gunstick |
| Contact Person: | Tschew (mail), Kwisatz (mail) |
| Tools | |
| QrCode: | 
|
"File:" cannot be used as a page name in this wiki.
see Special:Version for details on the OpenDuino Wiki extension.
Contents |
Usage
- There is a little button you can find near the two LEDs. If you are the first to enter the space, push it so that the green LED is on. If you are the last one to leave, push it so that the red LED is on (the red LED is glowing quite weak). This will then change the status on the webpage.
- After reboot or reset of OpenDuino it will recover the currently active open/close status shown on the webpage.
- Following a more general power loss, OpenDuino will go into the close state (red LED is on). If you don't put it into green mode, the closed status will be published to the website after 5 minutes.
- There is a webserver running on OpenDuino at http://openduino.lan/. it currently only shows the status of the LEDs
Features
- MW extension
- Set space status at the push of a button
- Supports plugins with a set of hooks
- Currently one plugin sends SMS on status change
- Another plugin could tweet, but we use Tweet2cat
Source
You can check out both the arduino and php parts of the source code by using
svn co svn://hackerspace.lu/openduino
Todo
- Integrate with Membership Management Tool
- Integrate rrdtool occupancy statistics
- Create notification messages dictionary file
- Integrate with alarm system
